Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1331/-
1 - Bolt
❑ 2x
❑ 20 Nm
2 - Bolt
❑ 2x
❑ 18 Nm
3 - Stepped pin
❑ 25 Nm
4 - Nut
❑ 25 Nm
5 - Seat height adjustment mo‐
tor
♦ Removing
– Remove the seat
⇒ page 282 .
– Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
– Attach the front seat to
the holder for seat repair
-VAS 6136- .
– Remove the side trim on
the sill panel side
⇒ page 292 .
– Remove the side trim on
the tunnel side
⇒ page 293 .
– Remove the cover -7-.
– Unscrew the bolts -1-
(2x) for attaching the
seat upper frame to the
seat base frame.
– Unscrew the bolts -2-
(2x).
– Screw out the stepped pin -3- and detach the nut -4-.
– Fold up the seat upper frame -6- at the front.
WARNING
Risk of injury if the seat
upper frame tips back.
Secure the seat upper
frame to stop it tipping
back.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front seats (memory seat, electrically operated seat) 303
To Next Page
Loading...
