Audi A8 2003 - Page 330

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Wiring harness
2 - Connector console
3 - Locating clip
♦ For fitting refer to Fig., wir‐
ing at connector console
⇒ Item 1 (page 321)
♦ The locating clip -3- must
always be fitted from under‐
neath.
♦ If missing, the locating clip
-3- must always be attach‐
ed to prevent cable abra‐
sion on the seat frame.
♦ Attaching missing locating
clip -3-
⇒ Item 5 (page 322)
♦ For attachment of locating
clip -3-, refer to
⇒ Item 5 (page 322) and
⇒ Item 3 (page 323) .
4 - Binding clip
♦ For fitting refer to Fig., wir‐
ing at connector console
⇒ Item 2 (page 321)
5 - Locating clip
♦ For attachment to centre
cross member
6 - Locating clip
♦ For attachment to outer
cross member
7 - Locating clip for seat height
adjustment motor wiring
8 - Seat height adjustment motor connector
9 - Seat height adjustment motor
Wiring at connector console
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
320 Rep. gr.72 - Seat frames