Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1410-
1 - Storage compartment
❑ With handset cradle
(optional)
♦ Removing
– Switch off ignition.
– Swivel centre armrest
-5- upwards.
– Detach upper support
trim -4-.
– Unscrew bolts -6- (2x).
– Detach centre armrest
-5- from lower support
-8-.
– Unclip grommet -3-.
– Unclip storage compart‐
ment -1-.
– Swivel storage compart‐
ment upwards and at
the same time pull it in
direction of travel out of
centre console -9-.
– Unplug connector on
vehicles with handset
cradle -2-.
– Take out storage com‐
partment -1-.
♦ Installing
Install in reverse order of re‐
moval.
2 - Handset cradle
❑ Removing and installing
⇒ Rep. gr. 91
3 - Grommet
4 - Upper support trim
5 - Centre armrest
❑ Split version
6 - Bolts (2x), 18 Nm
❑ Included in scope of delivery of centre armrest
7 - Upper support
❑ Included in scope of delivery of centre armrest
8 - Lower support
9 - Centre console
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
40 Rep. gr.68 - Interior equipment
To Next Page
Loading...
