Audi A8 2003 - Page 79

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Centre console with exten‐
sion
2 - Bolts (4x), 2 Nm
3 - Centre console air distribu‐
tor
❑ Rear left vent warm air
and cold air flap control
motor ( -V220- ) -4-
❑ Rear right vent warm air
and cold air flap control
motor ( -V221- ) -5-
❑ Rear left centre console
temperature sensor ( -
G311- ) -7-
❑ Rear right centre con‐
sole temperature sen‐
sor ( -G312- ) -6-
Removing
Note
– Remove extension for
centre console
⇒ page 59 .
– Remove centre console
for extension
⇒ page 51 .
– Remove bolts -8- and
-9- (4x).
– Pull rear left -10- and
rear right -11- air ducts
out of centre console air
distributor -3-.
– Unplug electrical connectors at rear left ( -V220- ) -4- and rear right ( -V221- ) -5- vent warm air and cold
air flap control motors.
– Unplug electrical connectors at rear left ( -G311- ) -7- and rear right ( -G312- ) -6- centre console tem‐
perature sensors.
– Unscrew bolts -2- (4x).
– Take out centre console air distributor -3-.
Installing
Install in reverse order of removal. Observe the following:
– Observe correct assignment when plugging in connectors at rear left ( -V220- ) -4- and rear right ( -V221- )
-5- vent warm air and cold air flap control motors.
– Observe correct assignment when plugging in connectors at rear left ( -G311- ) -7- and rear right ( -
G312- ) -6- centre console temperature sensors.
4 - Rear left vent warm air and cold air flap control motor -V220-
❑ Removing and installing ⇒ Rep. gr. 87
5 - Rear right vent warm air and cold air flap control motor -V221-
❑ Removing and installing ⇒ Rep. gr. 87
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Removing and installing centre console with extension 69