ASSEMBLY
(1) Mount th rust washer (4) (Fig. 220) with the
colla r pointing towards t he pla net car rier.
(2) Mount the rea r gear set (5) on the rear hollow
sh aft (6).
(3) Usin g grease, install lower t hree Teflon r ings
(1) (F ig. 220) in t he groove so that the j oint stays
toget her
(4) Put rea r hollow shaft/freewheelin g clutch F 2
(6) wit h rear gear set (5) onto ou tput shaft.
(5) In st all clutch K3 (7).
(6) Mount retainin g ring, shim, t hrust needle bear-
ing and thrust wa sh er (8 - 11) (F ig. 220).
(7) Usin g grea se, insert th e upper two Teflon r ings
(1) in t he groove so that the join t remains toget her.
Fig. 220 Output Shaft with Center and Rear Planetary Geartrain
1 - TEFLON RINGS 7 - DRIVING CLUTCH K3
2 - OUTPUT SHAFT WITH CENTER PLANETARY CARRIER 8 - THRUST WASHER
3 - NEEDLE BEARING 9 - AXIAL NEEDLE BEARING
4 - THRUST WASHER 10 - SHIM
5 - REAR PLANETARY GEAR SET 11 - RETAINING RING
6 - REAR HOLLOW SHAFT/FREEWHEELING CLUTCH F2
VA AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION 21 - 167
To Next Page
Loading...
