Dodge Sprinter 2006 - Page 1977

(2) Remove trim pa nel. (Refer to 23 - BODY/
DOORS - SLIDING/TRIM PANEL - REMOVAL)
(3) Disconn ect electrical conn ectors. (F ig. 9)
(4) Remove bolt s and rem ove cont rol assem bly.
(Fig. 10)
(5) Disconn ect lock knob r od. (F ig. 11)
(6) Disconn ect cable.
INSTALLATION
(1) Position latch /lock contr ol assembly a t door and
connect t he la tch contr ol assem bly and lock r od.
(2) In st all assembly and insta ll new bolts. Make
su re that th e l ever of the door handle is in front of
the lever of the inside door lock. (Fig. 12)
(3) Tighten bolts to 10 N·m (89 in . lbs.).
(4) Connect electrical connectors.
(5) In st all tr im panel. (Refer to 23 - BODY/DOORS
- SLIDING/TRIM PANEL - INST ALLATION)
(6) Connect batt ery n egat ive cable.
Fig. 9 ELECTRICAL CONNECTORS
1 - CONNECTOR
2 - CONNECTOR
3 - CONNECTOR
Fig. 10 LOCK ASSEMBLY FASTENERS
1 - SCREWS
2 - POWER LOCK ACTUATOR
3 - LATCH/LOCK CONTROL ASSEMBLY
4 - EXTERIOR DOOR LEVER
Fig. 11 LOCK ASSEMBLY
1 - LATCH/LOCK CONTROL ASSEMBLY
2 - LOCK ROD
3 - LOCK KNOB
4 - LATCH CONTROL CABLE
5 - ELECTRICAL CONNECTOR
6 - ELECTRICAL CONNECTOR
7 - INTERIOR HANDLE ACTUATOR
8 - STOP BUMPER
9 - TRIM PANEL
Fig. 12 LOCK ASSEMBLY FASTENERS
1 - SCREWS
2 - POWER LOCK ACTUATOR
3 - LATCH/LOCK CONTROL ASSEMBLY
4 - EXTERIOR DOOR LEVER
VA DOORS - SLIDING 23 - 39