Cargo Van - Rear
(1) Remove the scr ews and ret ain ing strips.
(2) Remove carpet /mat.
INSTALLATION
Cargo / Passenger Van - Front
(1) Position carpet /mat in vehicle.
(2) In st all the ja ck stor age cover.
(3) In st all the cup holder. (Refer to 23 - BODY/IN-
STRUME NT PANEL/CUP HOLDER - INSTALLA-
TION )
(4) In st all the tra y beh ind the driver ’s seat and
insta ll the t hree bolts.
(5) In st all t he stepwell scuff pads. (Refer to 23 -
BODY/INTERIOR/STEPWELL SCUF F PADS -
INSTALLATION)
Passenger Van - Rear
(1) Position carpet /mat in vehicle.
(2) In st all the seat striker assemblies.
(3) In st all the retaining strips and screws.
(4) In st all t he seats. (Refer to 23 - BODY/SEATS/
SE AT - INSTALLATION)
Cargo Van - Rear
(1) Position carpet /mat in vehicle.
(2) In st all the retaining strips and screws.
COWL T RI M
REMOVAL
(1) Position door weat herstrip aside.
(2) Remove the jack stor age cover, if necessa ry.
(3) Position aside carpet /mat, if necessary.
(4) Usin g a trim st ick C-4755 or equ iva lent ,
remove th e cowl t rim pan el.
INSTALLATION
(1) Position the cowl trim pa nel a nd seat the clips
fully.
(2) In st all the ja ck stor age cover, if n ecessary.
(3) Position the carpet /mat back.
(4) Position the door weath erstrips back.
D-PILLARTRIM
REMOVAL
(1) Remove th e th ree plastic twist screws an d
remove th e panel.
INSTALLATION
(1) In st all the pa nel an d in st all t he three t wist
scr ews.
HEADLINER
REMOVAL
Cab Section
(1) Remove the a-pillar trim . (Refer to 23 - BODY/
INTERIOR/A-PILLAR TRIM - REMOVAL)
(2) Remove the sun visors. (Refer t o 23 - BODY/
INTERIOR/SUN VISOR - REMOVAL)
(3) Remove the b-pillar tr im. (Refer t o 23 - BODY/
INTERIOR/B-PILLAR TRIM - REMOVAL)
(4) Remove the assist han dle. (Refer to 23 - BODY/
INTERIOR/ASSIST H ANDLE - REMOVAL)
(5) Remove the dome light. (Refer t o8-ELECTRI-
CAL/LAMPS/LIGHTING - INTERIOR/CARGO
LAMP UNIT - REMOVAL)
(6) Carefully separate the headliner and remove.
Number 2 Section
(1) Disconn ect and isolate battery negative ca ble.
(2) Remove the second and t hird row seats. (Refer
to 23 - BODY/SE ATS/SE AT - REAR - RE MOVAL)
NOTE: If vehicle is not equipped with rear air con-
ditioning unit, skip to step 8.
(3) Remove the push pin fasteners and rem ove the
rear a ir front du ct cover.
(4) Disconn ect t he electr ical con nector at front of
cover.
(5) Remove the push pin fasteners and rem ove the
rear a ir middle duct cover.
(6) Disconn ect the electrical conn ector.
(7) Remove the three push-pin s an d th ree screws
and rem ove the rea r air cover.
(8) Remove the du ct work.
(9) Relea se clips at fron t and rear of headliner and
remove.
Number 3 Section
(1) Disconn ect and isolate battery negative ca ble.
(2) Remove th e third and fou rth row sea ts. (Refer
to 23 - BODY/SE ATS/SE AT - REAR - RE MOVAL)
NOTE: If vehicle is not equipped with rear air con-
ditioning unit, skip to step 8.
(3) Remove the push pin fasteners and rem ove the
rear a ir front du ct cover.
(4) Disconn ect t he electr ical con nector at front of
cover.
(5) Remove the push pin fasteners and rem ove the
rear a ir middle duct cover.
(6) Disconn ect the electrical conn ector.
(7) Remove the three push-pin s an d th ree screws
and rem ove the rea r air cover.
(8) Remove the du ct work.
VA INTERIOR 23 - 73
To Next Page
Loading...
Need help?
General
