The X Axis Drive Assembly
7-54 DSX™ System Service Manual
To Replace the X-Drive Belt:
1 Fit the Fixed X Belt Block (Part No. 204002600), with the belt (Part No. 40000160)
to the end of the datum face (Figure 7-63). Ensure that the belt is properly located
and flush with the end of the block. Use 4 M3 x 12 skt cap screws; apply Loctite
222 and secure the screws.
Note: The threaded hole must face to the left.
Figure 7-63 Mounting the Fixed Block
To Next Page
Loading...
