Repairing/Replacing Internal Components
11-20 DSX™ System Service Manual
4 Place the pulley on the motor shaft (Figure 11-13). Set the position of the pulley
using the pulley gauge P/N AMFIX002. Fasten the pulley using the setscrew and
Loctite #242.
Figure 11-13 Motor and Pulley
5 Rewrap the belt around the motor pulley. Loosely fasten the motor to the chassis
using 4 M3 x 6mm socket head cap screws, M3 flat washers and M3 lock
washers. Route the wire from the motor to the right in the back. Apply 7 in-lbs of
torque to tighten the screws.
Note: When tightening the screws, use torque driver SN160 to tighten the
screws to 7 in-lbs.
To Next Page
Loading...
