Hioki IM3570 - Page 454

Index10
Sweep end value setting 145
Sweep point setting 143
Trigger synchronous output
function setting
104,
235
System settings 22
Set delimiter to tab 338
Move cursor to measurement
value set in option settings
190
Save measurement results as
text
333
Panel test 307
Trigger delay setting 140
Trigger setting
55,
137
Setting for type of data to save
to USB
333,
341
Disable key lock
121,
230
Enable rising edge 117
Upper limit value setting
Selecting the equivalent circuit
estimation results display posi-
tion
251
Upper and lower limit value
settings
185
USB settings 22
Open-circuit voltage sweep 135
Setting for measurement value
to find
191
Set upper and lower limit val-
ues as absolute values relative
to reference value
203
Check file content 343
Reactance (
)25
Set handshake to software
(Refer to the Communication
Instruction Manual (CD))
Admittance (S) 25
Key Description
Refer-
ence
Impedance () 25
Disable enlarged view of mea-
surement values
126
Enlarge measurement values 126
Set cable length to 0 m 301
Set cable length to 1 m 301
Switch numerical input method
41,
158
Deviation percentage mode
setting
91,
101
Impedance phase angle ()25
Percent mode setting 89, 98
Set upper and lower limit val-
ues as percentage values rela-
tive to reference value
201
Set measurement frequency to
×1/10
42
Set measurement frequency to
×10
42
Set setting value to
×1000
Set setting value to
×1/1000
Set quotation mark to double
quotation mark (“)
339
Set delimiter to comma (,) 338
Set delimiter to semicolon (;) 338
Move cursor to left by 1 sweep
point
193
Move cursor to right by 1
sweep point
193
Select top item
Select bottom item
Key Description
Refer-
ence