Hioki IM3570 - Page 453

Index
Index9
Reference value settings
Change save name 320
Repeat sweep setting 138
System Reset
129,
237
Right limit value setting 213
Selecting the equivalent circuit
estimation results display posi-
tion
251
ROM/RAM test 312
Effective resistance in parallel
equivalent circuit mode (
)
25
Effective resistance in series
equivalent circuit mode =
ESR(
)
25
RS-232C setting 22
Executing equivalent circuit
analysis
253
Change save folder 344
Save
Save type setting 318
Scale setting
177,
183
Scaling setting 302
Perform scaling compensation
for parameter 1
303
Perform scaling compensation
for parameter 2
303
Perform scaling compensation
for parameter 3
303
Perform scaling compensation
for parameter 4
303
Print hardcopy of screen 383
Search 194
Apply settings of first segment
to all other segments
182
205
Key Description
Refer-
ence
Segment settings 142
Segment span mode setting 179
Setting the segment for which
to perform equivalent circuit
analysis
245
Check contents of file 343
Sequential sweep setting 138
Measurement condition setting 14
Confirm settings
Use external DC bias unit 57
Short compensation 280
Simulating frequency charac-
teristics
258
Single span mode setting 179
Measurement speed SLOW2
setting
59,
77,
164,
174
Measurement speed SLOW
setting
59,
77,
164,
174
Sweep parameter settings 135
Set delimiter to space 338
Span Setting 179
Measurement speed setting
59,
77,
164,
174
Spot compensation settings
277,
285
Sweep start value setting 145
Start value of sweep and step
width of sweep point settings
146
Start value and end value of
sweep settings
145
Step sweep setting 138
Step width of sweep point set-
ting
146
Key Description
Refer-
ence