iPECS UCP600 - Page 123

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
109
Table 4.4.4.1-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
CO Line Type
Each CO/IP Line can be assigned as connected to a CO Line or a
PBX/CTX Line.
PBX
CO
CO
Universal Night
Answer
Universal Night Answer (UNA) allows any station user to answer a
CO/IP line call by dialing the UNA code.
OFF
ON
OFF
CO/IP Group
Authorization
Each CO/IP Group can be assigned to require the user to enter an
Authorization Code.
OFF
ON
OFF
CO Tenancy
Group
Only stations in the assigned Tenancy group are permitted access
to the defined CO Line.
0-15(eMG80/100), 0-32(eMG800), 0-100(UCP)
Refer to
description
0
CO/IP Name
Display
IF ASSIGNED BELOW, the IP Phone display can indicate the CO
line/IP channel number or the twelve (12) character name.
OFF
ON
OFF
CO Name Assign
Each CO Line and IP group can be assigned a twelve (12)-
character name for display purposes.
Max. 12
characters
DISA Account
Code
With DISA Account Code “ON,” users are required to enter a
DISA Authorization code. Codes are entered in the ‘Authorization
Code Table section.’
OFF
ON
ON
DISA CO Access
When enabled, DISA users may access the VoIP facilities of the
system.
OFF
ON
OFF
Wait If VSF Busy
When a DID/DISA call assigned to receive a VSF announcement
arrives, and all channels are busy, the call may wait with Ring
back until a channel is available (ON) or route to the DID/DISA
Destination -PGM 167-.
OFF
ON
ON
SMS Outgoing
Each CO line can be assigned to support PSTN SMS.
Disable
Enable
Disable
SMS Received
Station
When a PSTN SMS is received, the system delivers the message
to the assigned station.
Station
….
Reject
Anonymous
Incoming Call
When REJECT ANONYMOUS is enabled, incoming calls without
a Caller ID are rejected.
OFF
ON
OFF
Prefix Table ID
When the Prefix Dialing Table (PGM 206) feature is used, this
Prefix Table ID is employed. If this value is set to 0, the Prefix
Table feature is disabled.
0 – 6.
0(Disable)
0
LDT Table Index
When LCR is configured, this LDT Table index is referenced for
outgoing calls on this CO/IP Line.
0-10(eMG80/100), 0-32(eMG800), 0-32(UCP)
Refer to
description
1
LDT Zone
Number
If the LDT Zone Number of an LDT table (LCR LDT(221)) is equal
to this value, the LDT table is available to this CO Line.
1-100
1
ENBLOCK
Sending
This entry determines if the system sends dialed digits to the
ISDN line as they are received (OFF) or collects all digits and
forwards them in a block. (ON).
OFF
ON
ON
DID preserve
Name
For DID lines, the CLI is normally displayed only during ringing. If
enabled here, the CLI will be displayed for the entire call duration.
OFF
ON
OFF