iPECS UCP600 - Page 124

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
110
Table 4.4.4.1-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Burst Tone to
Caller
When DID Call Wait is assigned for the station, the system can
send audible off-hook signals as a short burst of tone for DID calls
from this CO/IP Line.
OFF
ON
OFF
Collect Call
Blocking
This parameter defines the type of Collect Call Blocking supported
for E1 CO lines with R2 signaling. (Intended for Brazil
only)Disable, Double Answer, Double Answer w/Indication
Refer to
description
Disable
Collect Call
Answer Timer
These parameters determine the treatment of an incoming call
when Collect Call Blocking Double Answer is assigned. In this
case, the system answers the call and maintains the connection
for the Call Answer time. Then, the system will disconnect for the
Call Idle time before finally reconnecting the call.
1-250
(100ms)
10
Collect Call Idle
Timer
1-250
(100ms)
20
Gain table index
One of three Gain tables can be configured for TDM connections.
1-3
1
Tone table index
One of the five Tone tables can be configured for use with the
CO/IP Line.
1-5
1
Digit conversion
table index
One of the Digit Conversion Tables can be configured for use for
this CO/IP Line.
1-15(eMG80/100), 1-32(eMG800), 1-32(UCP)
Refer to
description
1
Prepaid Call
The Pre-paid Call feature must be enabled for use by a station.
Users can set the budget for the station call charge in advance.
OFF
ON
OFF
Prepaid Money
(0-999999)
&
Used Prepaid
Money
An amount can be associated with the station as a prepayment for
outgoing calls. The assigned “Pre-paid Money” is reduced by the
calculated call cost (Call Metering or cost/minute). This parameter
displays the remaining funds for outgoing calls. Prepaid Money is
often used in small hospitality businesses.
The “Used Pre-paid Money” displays the money that has been
used.
0-999999
0
Automatic call
recording
destination
When desired, the IP CR server can be used to record calls on
the CO/IP Line. This value defines the Station Group of the IP CR
server. The IP CR Agent object, see PGM 237, must be assigned
as CO Line for proper operation.
ICLID Usage
An incoming call can be routed to the destination based on the
Calling Name.
 Disable - ICLID feature is disabled
 CLI - ICLID feature is operated with CLI
 Name, CLI - ICLID feature is operated with Name and CLI
Refer to
description
CLI
PBX Code
Insertion for
Emergency call
The system can insert PBX code automatically if pre-configured
when a user makes an emergency call.
Disable, PBX code1~4
Refer to
description
Disable
Timer Attributes
Cut Off Timer
When the Station is assigned Call Time restriction is assigned,
this timer defines the allowed call duration.
00-99
00 =
disable
0