iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
128
Table 4.4.4.11-1 CID/CPN ATTRIBUTES
Calling party
numbering Plan
ISDN Calling Party Numbering Plan can be configured.
Unknown, ISDN/Telephony, Data/Numbering, Telex,
National Std, Private, Reserved
Called party
numbering Plan
ISDN Calling Party Numbering Plan can be programmable.
Unknown, ISDN/Telephony, Data/Numbering, Telex,
National Std, Private, Reserved
When the Station CLI is used with the CLIP or CLOP, one of five
Station CLIs as defined in PGM 114 section 4.4.7.2 is used for
this CO/IP Line as selected here.
When a DID call is received on an ISDN Line, this entry
determines the number of digits that will be removed starting at
the first received digit.
Selects one digit remove mode in ISDN Called Digits for Italy DID.
The type of CID signal can be assigned according to the type of
CID from the carrier.
Disabled, FSK, DT-AS(TAS) FSK, DTMF, RCID
RCID Request
First Delay
Timer
Russia CID First Delay Timer.
Russia CID No–Answer Timer.
Russia CID Request Count.
RCID Request
Retry Delay
Timer
Russia CID Retry Delay Timer.
To use LD(Long Distance) Digit Count, the 'My Area Prefix code'
must be set in advance. This option enables the call log to add
'My Area Prefix Code' If Incoming CLI is shorter than 'LD DIGIT
COUNT' and is not matched with Multi Area Code or without
change if Incoming CLI is equal to or longer than 'LD DIGIT
COUNT.' The default is 11 for North America and 0 for other
countries.
To Next Page
Loading...
