iPECS UCP600 - Page 149

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
135
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Automatic
Privacy
Automatic Privacy can be disabled, allowing stations to join an
active CO/IP call. A warning tone can be provided. See Privacy
Warning Tone below.
OFF
ON
ON
Privacy Warning
Tone
If desired, a warning tone can be provided when privacy is
overridden.
OFF
ON
ON
ACD Print
Enable
ACD statistics can be periodically sent to the assigned serial
port. To provides the periodic reports, this feature must be ON.
OFF
ON
OFF
ACD Print Timer
This entry defines the time, in 10-second increments, between
the periodic ACD reports assigned above.
001~255
(1 sec)
10
CALL
TRACKING
Enable
It transfers the tracking information to 3rd Party VM SIP.
OFF
ON
OFF
Clear ACD
Database
When a periodic report is sent, the ACD database can be
cleared automatically if “ON.”
OFF
ON
OFF
Override 1st CO
Group
When a user dials ‘9’, the system can search all CO/IP Groups
for the first available CO/IP line.
OFF
ON
OFF
Codec Type
The default codec can be defined as G.711, G.729, G.722, or
G.723.1 for decreased bandwidth needs. The selected codec
will be used on all internal communications as well as for remote
iPECS devices.
G.729/
G.723.1/
G.711/
G.722
G.711
G.711
Packetization
The G.711 voice frame packetization time determines the
interval at which voice samples are packetized and sent when
the G.711 codec is used.
10/20/30
(1 msec)
020
G.723
Packetization
The G.723.1 voice frame packetization time determines the
interval at which voice samples are packetized and sent when
the G.723.1 codec is used.
30/60
(1 msec)
030
Network
Time/Date
The system can use ISDN Network time or NTP to synchronize
time with the ISDN or data network.
ISDN sync is not available in the USA version.
Disable/
ISDN/
NTP
Disable
Incoming Toll
Check
The system can invoke COS dialing restrictions when a user
dials while connected to the incoming call.
OFF
ON
OFF
Web Server
Port/TLS for Web
This field determines the TCP port employed to access the
system WEB server. This field also enables Transport Layer
Security (TLS) for access to Web Admin.
00001-65535/Enable or Disable
Refer to
description
443/
Enable
REST API
Service Port
The REST API Service Port is the TCP port for the REST API
service. It will be started with the web admin server after
refreshing when you assign or change the port.
0(Unused), 1024-65535
Refer to
description
0
REST API
Session Timeout
The REST API Session Timeout value means the duration for
REST API service after login with ID and Password. After the
timeout value, the session will be expired if there are any
requests from the user.
1-60
(1 min)
2