iPECS UCP600 - Page 152

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
138
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
IGMP query all
host
IGMP queries are sent to all IP hosts (ON) on the network or to
iPECS devices only. For All Hosts, IP address 224.0.0.1 is used.
Otherwise, the iPECS specific 239.20.19.50 IP address is used.
If problems occur with MOH, the “All Hosts” may correct the
issue.
OFF
ON
ON
IGMP query
generic
This entity specifies a group address being queried. If ON is
selected, all multicast groups are queried. If OFF is selected,
iPECS registering device group (239.20.19.50) is queried only.
This should be ON when there is a MOH problem.
OFF
ON
OFF
Restrict star and
pound
If enabled, calls using * or # as the first digit are prohibited by
the system.
OFF
ON
ON
Restricted
Dialing Display
After Answer
If a restricted number is called, the system will output an SMDR
record for the call after the call is answered.
OFF
ON
ON
IP BIND USAGE
If It’s ON, VOIU/VOIB/VOIM will apply IP-Binding with
information in PGM130 / PGM133 (Media port).
OFF
ON
OFF
New 5 Wake Up
Usage
With the “New Wake-Up” option, the user can assign five-alarm
notification times; otherwise, only one Wake-Up time can be set.
OFF
ON
OFF
Easy 5 Wake Up
Usage
If this value is set to ON, and New 5 Wake Up Usage is also set
to ON, each station user can enter his/her wake up time without
entering wake up type and wake up an index.
OFF
ON
OFF
Station VM
Feature Usage
The Station VM feature (PGM 127) can be used if this option is
set to ON. Enhanced features of the VSF/UVM can be disabled.
Features controlled by this setting include as below:
 Company Directory
 Remote Announcement Recording
 Administrator Mailbox
 Distribution List
 Mark a Message as Private,
 Urgent or Delivery Confirmation
 Record Greeting through CCR
 Voice Mail Class of Service
OFF
ON
OFF
End code(#)
usage in System
Auth Code
If this option is set to ON, the End code (#) must be entered
when the system Auth code is entered.
OFF
ON
OFF
Remote VM
Access
If this value is OFF, the user cannot access to VSF mailbox via
DID, DISA CO call, and so on (i.e., through CO line channel).
OFF
ON
ON
Transfer Tone
Usage
If this value is ON, a Warning tone is served to the [transfer to]
station. This is only applied to the screened transfer case.
OFF
ON
OFF
CID Password
Usage
If this value is ON, a user must enter the CID password to
modify an admin value about the CID setting.
OFF
ON
OFF