iPECS UCP600 - Page 153

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
139
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
LCR Dial Tone
Detect
If this value is set to ON, the system first checks dial tone in the
case on analog CO Lines then LCR dialing is completed. If no
dial tone is detected, the call is rerouted to Alternate DMT Index.
If the LCR type is set to M13, the LCR dial tone detect option is
not applied.
OFF
ON
OFF
Mobile Phone
Presence
Service port
This is for an interface between eMG and an external server that
sends http/xml data. Currently, the first usage of this port is the
‘mobile phone presence’ service.
If set to a valid port, the presence service will be implemented,
and the system will await messages for presence from the
external server.
00001~
65535
00000
Mobile Phone
Presence State
Sync
When the system receives presence information for a mobile
extension from the external server, the system synchronizes the
station’s call state with this presence information. A busy
presence will set the station to busy.
OFF, DSS LED only, Station Status
Refer to
description
Station
Status
Mobile Phone
Presence Force
Idle Timer
The system will return a station’s state to idle if there is no
updated presence information from the external server for the
duration of this timer.
0~3600
(Sec.)
0
Attendant
Password Usage
If this value is set to ON, the system requests a password:
When a user enters Attendant program ([PGM] + 0,
When an Attendant enters the Speed program,
When a user assigns attendant program code ([PGM] + 0) to the
Flexible button,
OFF
ON
OFF
Picked-up station
name usage
The name of the picked-up station is displayed when pickup an
internal call.
OFF
ON
OFF
Display LCR
mode
Display “LCR MODE” when LCR is activated.
OFF
ON
ON
VM Notify to
Mobile Extension
over CO
If this value is set to ON, an analog Loop Start CO Line can be
used for the VM notification call to the Mobile Extension.
Disable
Enable
Disable
MODEM
Associated
Station/CO line
The call is routed to the system's built-in modem when the
assigned CO Line receives a call. This option is available only
for eMG80/100& eMG800.
eMG80/100: STA/239, eMG800: STA/ 2199
CO/STA
Refer to
description
Display {MEET
ME} Soft button
If this value is set to OFF, {MEET ME} soft button is not
displayed during a paged.
OFF
ON
ON
Number of CLI
Wait List
The system checks the status of each device with a polling
message periodically using this timer.
0-255
0
Emergency
Mailbox Station
When an Emergency Mailbox Station is assigned, an emergency
call placed by a station is recorded automatically to the assigned
mailbox.