iPECS UCP600 - Page 205

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
191
Table 4.4.5.28-1 SYSTEM TIMERS
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Door Open Timer
This timer sets the minimum time required to activate the contact
assigned as a door open contact.
00~99
(100 msec)
20
ICM Dial Tone
Timer
If a user goes off-hook to receive an Intercom dial tone and
takes no action for this timer, the user will receive an error tone.
001~255
(seconds)
10
Inter Digit Timer
This timer sets the maximum time allowed between each user-
dialed digit. At expiration, the user will receive an error tone.
01~20
(seconds)
5
MSG Wait
Reminder Tone
Timer
An iPECS IP or LDP Phone user will receive periodic reminder
tones of a message waiting at intervals of this timer.
00~60
(minutes)
00
Paging Timeout
Timer
Determines the maximum duration of a page after which the
caller and Page Zone is released.
000~255
(seconds)
15
Pause Timer
A Timed pause of this duration is used in speed dial and during
other automatically dialed digits sent to the PSTN.
1~9
(seconds)
1
Soft auto RLS
Timer
When a Soft Key is used on the 6000 or 7000 series iPECS IP
or LDP Phone, after the expiration of this timer, the display will
return to the previous display.
1-30
(seconds)
10
VM Pause Timer
When the system sends a “Pause” to Voice Mail using in-band
signals, this timer defines the Pause duration. (Not available in
the USA.)
1-90
(ms)
30
SLT Hook Switch
Bounce Timer
This timer determines the system's duration considers an actual
state change in the hook-switch and not a spurious contact
bounce.
01~25
(100 msec.)
1
SLT Maximum
Hook Switch
Flash Timer
This timer sets the maximum time an SLT user can depress the
hook-switch for a Flash signal.
01~25
(100 msec.)
1
SLT Minimum
Hook Flash
Timer
This time sets the minimum time an SLT user must depress the
hook-switch for a Flash signal.
000~250
(10 msec.)
4
Station Auto
Release Timer
The system will return a station to idle for an internal call if the
call remains unanswered for this duration.
000~300
(seconds)
60
Unsupervised
Conference
Timer
This timer determines an “Unsupervised Conference” duration
before the station is recalled or the conference is dropped. 00
means 10 minutes.
00~99
(minutes)
10
Prime-Line Delay
Timer
This timer sets the delay (no action duration) for delayed (Warm)
Prime Line operation.
01~20
(seconds)
5
Wink Signal
Timer
This timer sets the duration of the “Seize Acknowledge Signal”
(Wink) sent to the PSTN on a DID line.
010~200
(10 msec.)
10
En-block Inter
Digit Timer
When an ISDN Line is assigned to send digits En-block, CO
Attribute section, the system will send digits if the user dials “#”
or this En-block inter-digit timer expires.
01~20
(seconds)
5
DTMF Duration
Timer
This timer establishes the duration of DTMF tones sent on an
analog CO line.
04~99
(10 msec.)
10