iPECS UCP600 - Page 207

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
193
Table 4.4.5.28-1 SYSTEM TIMERS
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Fax Detect timer
It is the maximum fax tone detection time to deliver FAX calls to
the fax destination.
1~20
(1 sec.)
10
Auto Pause
Release timer
This auto-pause released timer will release IPCR Mute function.
0~255
(1 sec.)
0
UCS Ring ACK
Timer
UCS Client is ringing before expiring the Ring ACK timer and
afterward will hear Error tones.
0~20
(seconds)
0
Short Modem
Timer
If {Short modem} of an SLT is ON, the SLT maintains the
modem mode for this time.
01~60
(1 sec.)
10
Button Idle Timer
When a button is pressed, an auto-idle timer is added. A button
is pressed in an idle state. It goes to a menu list state(not calling
state).In the menu list state, this auto-idle timer is applied.
The button that is applied to this timer is as below.
 Transfer / PGM.
 Speed.
 Menu.
 Directory.
 Message.
 Call Log.
Condition
The Button Idle timer is supported only below phones.
 LIP-90xx series(9010/20/30/40)
 LIP-80xxE series(8012E/24/40E)
 LDP phones.
The firmware of the LIP-90xx & LIP-80xxE series should be
upgraded.
 LIP-90xx: A.0Eb or later version
 LIP-80xxE: A.1Fn or later version
The DECT phone and LIP-9070 do not support the Button Idle
timer.
00,
10-99
(1 sec.)
0
CCR No Digit
Error Timer
'CCR No Digit Error Timer' is the specific time when the digit is
not entered after the announcement.
After CCR no digit error timer, the call is routed to 'Error
destination' that is set in CCR Table (228).
01-99
(100ms)
50
Fax No Answer
Timer
When Data(Fax) station number is defined in the analog CO
line, the system automatically answers the incoming call to
detect the Fax tone. If the fax tone is not detected, the call is
routed to the ring assigned destination. If the destination does
not answer the call, it is disconnected after fax no answer timer
is expired.
10-99
(1 sec.)
30