iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
229
Table 4.4.6.3-4 EXTERNAL VOICE MAIL GROUP ATTRIBUTES
For external analog Voice Mail groups, an index to the
Voice Mail Dial Table that contains the “Put Mail” dial
code.
For external analog Voice Mail groups, an index to the
Voice Mail Dial Table that contains the “Get Mail” dial
code.
The type of Station Group process applied to the SLT
ports connected to the VM can be assigned as Circular
or Terminal.
A call to a group will remain at the last station in the
group or be sent to the assigned Overflow Destination
after the expiration of the Overflow Time.
A call to the group will continue to route through the
group until answered or all group members have been
tried. The call will remain at the last station or will route
to the assigned Overflow Destination. If assigned VSF
Announce, Auto Drop is available.
STA/NET or Station Group,
VSF Announcement,
Auto Drop,
System Speed
Forced Forward
Destination
Calls to a Station group may forward directly to a
defined destination, bypassing the hunt process.
“Forced Forward,” below, must be enabled.
STA/NET or Station group,
VSF Announcement,
Sys. Speed
Forced Forward Dest
Usage
Calls to a Station group may forward directly to a
defined destination. See above “Forced Forward
Destination” when Forced Forward is enabled for the
group.
A group name can be designated.
When a third-party SIP server is used for AA/VM, or
the IPCR or third party SIP recording server is used,
the server type must be selected.
Each IPCR and third-party SIP server must be
assigned a server number from 01 ~ 10, which
correlates this group with an Agent table.
Member type is assigned as SLT type or SIP Type. In
the case of SIP Type, enter the capacity as below.
eMG80/100:0-140, eMG800:0-1200, UCP:0-2400
(SLT Type/ SIP Type)
To Next Page
Loading...
