iPECS UCP600 - Page 242

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
228
Table 4.4.6.3-3 RING GROUP ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Forced Forward
Destination
Calls to a Station group may forward directly to a defined
destination, bypassing the hunt process. “Forced Forward,”
below, must be enabled.
 STA/NET or Station group,
 VSF Announcement,
 Sys. Speed
Refer to
description
Forced Forward
Dest Usage
Calls to a Station group may forward directly to a defined
destination. See above “Forced Forward Destination” when
Forced Forward is enabled for the group.
OFF
ON
OFF
Ring group
indication
When a station calls a Ring Group, DSS/BLF buttons assigned
for the calling station will flash, and the muted ring is received.
OFF, ON (Ring and LED), ON (LED only)
Refer to
description
ON (Ring
and LED)
Ring Tone
When a call is routed to a group, a programmed ring tone is
served to the group member.
00-16
(00:N/A)
0
Group Ring Back
Tone
When a group member is ringing for the group, The ring-back
tone can be provided to the caller according to the ring-back tone
for the group.
 Ring back tone: ring back tone is provided when the
member of the group is ringing
 MOH: MOH is provided when the member of the group is
ringing.
 MOH (after connection): MOH is provided when the
system answered the call
Refer to
description
Ring back
tone
Figure 4.4.6.3-4 External Voice Mail Group Attributes
Table 4.4.6.3-4 EXTERNAL VOICE MAIL GROUP ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Wrap-Up Timer
After terminating a group call, the VM port will be
maintained in a busy state for the duration of the
Wrap-Up timer.
000~900
(seconds)
002