iPECS UCP600 - Page 246

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
232
Table 4.4.6.3-7 FEATURE SERVER VOICE MAIL GROUP ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
VSF
Announce 2
Auto Drop
If this attribute is selected, the call will drop after the 2nd VSF
announcement.
Check box
VSF
Announce 2
Repeat Timer
The 2nd announcement can be repeated to calls that remain in the
queue at intervals of the announcement 2 repeat timer. Note VSF
Announce 2 Repeat below must be “ON.”
000~999
(seconds)
000
VSF
Announce 2
Repeat
After the 2nd announcement, if the call remains queued to the group,
the 2nd VSF announcement can be repeated at the VSF Announce
Repeat timer interval above.
OFF
ON
OFF
Overflow
Destination
A call to the group will continue to route through the group until
answered or all group members have been tried. The call will remain
at the last station or route to the assigned Overflow Destination. If
assigned VSF Announce, Auto Drop is available.
 STA/NET or Station group
 VSF Announcement
 Auto drop
 System Speed
Refer to
description
Overflow
Timer
A call to a group will remain at the last station in the group or route to
the assigned Overflow Destination after the expiration of the Overflow
Timer.
000~600
(seconds)
180
No Answer
Timer
Calls to a station in the group are directed to the station if unavailable
or unanswered in the No Answer Timer. The call can be routed
based on the assigned hunt process.
00~99
(seconds)
15
Pilot Station
Group
An FS-VM Station group can be set so that only calls to the pilot
number (station group number) will hunt.
OFF
ON
ON
Alternate
Destination
When a call comes into the group and no group members are
available, the call will be routed to the assigned Alternate Destination.
STA/NET or Station group, System SPD
Refer to
description
Station Group
type
The Station group process for the FS-VM group can be defined as
Circular or Terminal.
Circular/
Terminal
Circular
Wrap-Up
Timer
After terminating any call, the FS port will be maintained in a busy
state for the duration of the Wrap-Up Timer.
000~999
(seconds)
2
Forced
Forward
Destination
Calls to a group may forward directly to a defined destination,
bypassing the hunt process. “Forced Forward,” below, must be
enabled.
STA/NET or Station group, VSF announcement, Sys. Speed
Refer to
description
Forced
Forward Dest
Usage
Calls to a Station group may forward directly to a defined destination.
See above “Forced Forward Destination” when Forced Forward is
enabled for the group.
OFF
ON
OFF
Group Name
A group name can be designated.
Max. 12
characters