iPECS UCP600 - Page 271

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
257
Table 4.4.8.3-1 SIP CO ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Proxy
Registration
Timer
Periodically, the system must re-register with the SIP Registrar.
While this timing is often negotiated with the Registrar, the system
can be configured to establish the re-register interval with this
timer.
1-65535
3600
Proxy Server
UDP Port
When employing UDP transport, this port number is employed for
messages to the SIP proxy.
Port
5060
Proxy Server
TCP Port
When employing TCP transport, this port number is employed for
messages to the SIP proxy.
Port
5060
Proxy Server
TLS Port
When employing TLS transport, this port number is employed for
messages to the SIP proxy.
Port
5061
Registration
UID Range
The User Id indices from the SIP User ID Attributes Table PGM
126 that will register with the SIP Service Provider’s SIP Registrar
must be configured.
Max. 140
Entries
DTMF Type
DTMF dialing signals can be sent from the system using in-band
or various Info messages. The method or type must match the
SIP Call Server.
 INBAND, 2833,
 INFO (DTMF),
 INFO (DTMF RELAY),
 INFO(TELEPHONE EVENT),
 INFO(NORTEL NETWORKS)
Refer to
description
INBAND
Action with
REG Failure
When registration fails, the link is down to the SIP Call server, or
the system receives no response to an Invite message in the “Call
Setup No-response” timer below, the call will return an error tone
(Wait Idle), or Fail-over to a Line from the Fail-over CO Group
specified below (Idle).
IDLE/
WAIT IDLE
IDLE
Secondary Proxy Server
Secondary
Proxy Server
Address
It is used for SIP proxy server redundancy.
KOREA telecom only.
IP Address
Secondary
Domain
It is used for SIP proxy server redundancy.
KOREA telecom only.
Max. 32
Characters
Secondary
Proxy Server
UDP Port
It is used for SIP proxy server redundancy.
KOREA telecom only.
Port
ID Presentation Option
ID Usage
P-Asserted-ID
The system normally provides a P-Asserted ID in SIP messages.
The system can be configured not to provide the header.
Unused
Use
Use
Remote-Party-
ID
The system normally provides a Remote-Party-ID in SIP
messages. The system can be configured not to provide the
header.
Unused
Use
Use