iPECS UCP600 - Page 285

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
271
Table 4.4.8.6-1 SIP User ID ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Authentication
User ID
The SIP Service Provider may require authentication of the user
for registration and during call setup. The Authentication name
from the provider must be entered for proper SIP registration.
Max. 64
characters
Authentication
User Password
The SIP Service Provider may require authentication of the user
for registration and during call setup. The Authentication
password from the provider must be assigned for proper SIP
registration.
Max. 32
characters
Contact Number
The Contact header of SIP messages is populated with the
specified SIP User ID.
Max. 16
characters
Contact Display
Name
The Display Name specified is used for the Contact header
Name field.
Max. 21
characters
Associative
Station Number
Not used.
Station
number
User ID Register
The SIP Trunks are provided in two formats.
 Registered: the system must register for service, often
using Authentication
 Provision: the provider sends all SIP messages to a fixed
IP; the system does not register for service.
Refer to
description
Provision
Authorized
Representative
ID Table Index
The User Id can be assigned an index of another User ID. When
the SIP CO is configured to employ the Authorized
Representative Id as the SIP “From” or “Contact” header, the
indexed User ID is employed.
eMG80/100:0~140, eMG800:0~1200, UCP:0~2400
Refer to
description
0
User ID Usage
If registration is enabled (User ID Register above), the iPECS
can send the User ID or Authorized Representative ID to the SIP
Proxy to register the ID. Otherwise, only the Authentication
Name and password are used.
OFF
ON
OFF
Ring Route Type
Incoming calls from a SIP trunk can be routed
to the ID assigned Station (any station with any of the SIP User
ID Table Indices in PGM 111 matching the incoming SIP User
Id),
based on CO/IP Ring assignments (PGM 144),
using DID treatment defined below table.
Follow the MSN Table routing (PGM 145).
 ID Assigned Station,
 Ring Assignment,
 DID Conversion,
 MSN-DID Conversion(PGM145)
Refer to
description
ID assigned
Station