iPECS UCP600 - Page 296

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
282
Table 4.4.8.8-1 SIP PHONE PROVISIONING
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Signaling Port
When the SIP phone transports the message to the system,
this port number is employed for messages from the SIP
phone.
Port
(1-65535)
5060
Preferred Voice CODEC Priority
1st priority ~ 4th
priority
When the system negotiates with the SIP phone, the Codec
priority specified is employed. If only the 1st. Priority Codec
is defined, only that Codec is available from the phone.
If the remote party does not support the Codec, the call will
fail.
G.711-u
G.711-a
G-729
G.722
None
NTP Setting (Need for TLS)
NTP Server
Address
The IP8800 series phones employ NTP to determine the
time of day. The NTP server-id must be configured for the
phone.
Max. 32
Characters
NTP Interval
The phone periodically checks the NTP server to determine
the proper time of day.
0-120(Hours)
1
NTP Time Zone
The phone must be configured with the local Time Zone for
proper operation and time display.
GMT
DST Usage
The phone must be configured to support Daylight Saving
Time.
ON
OFF
OFF
DSP Setting
Speaker Volume
The default volume level of the SIP phone speaker can be
set through the Config file.
1-11,
1-7 (IP8850)
6
Handset Volume
The default volume level of the SIP phone handset can be
set through the Config file.
1-11,
1-7 (IP8850)
6
Headset Volume
The default volume level of the SIP phone headset can be
set through the Config file.
1-11,
1-7 (IP8850)
6
MAX Handset
Volume
The default maximum volume level of the SIP phone
handset can be set through the Config file.
1-11
11
Digit Map
Dial Tone Digit
A digit string can be defined in the Config file so that the SIP
phone will provide a “Second Dial Tone” to the user.
Max.
256Digits
Inter Digit Timer
Inter digit timer between Dial digit in SIP Phone.
01-20(Sec.)
3
Pause Timer
Dial Pause timer in SIP Phone.
01-20(Sec.)
3
Digit Map
Send setup to system numbering plan.
Max. 1000
Emergency Code
The Emergency dial code for the SIP phone can be set
through the Config file.
Max. 1000
System Setting
Feature Sync.
With Do Not Disturb and Call Forward feature
synchronization ON, when SIP Phone changes the DND or
Call Forward state, the system is informed of the change in
status.
ON
OFF
ON