iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
299
Enter System Index Range: eMG80/100: 1-360 / eMG800: 1-1200 / UCP: 1-2800
Figure 4.4.9.9-2 System Authorization Code Table
Users can change COS for the system index range across the board and click the Range save button to save.
Authorization codes are employed to control access to system resources and facilities. Walking COS, CO/IP
Group access, DISA calls, and certain Call Forward types may require the input of a valid Authorization code.
Codes up to 12 digits may be entered into the system database.
There are two types of Authorization codes, station, and system. The Station entries are associated with
individual stations. The number of system Authorization codes varies based on the configuration; the number
of available codes is provided in Table 2.1-x. Each Authorization code may be assigned a separate COS for
Day, Night, and Timed Ring mode operation.
The system will allow the station-associated Authorization codes to be duplicated. However, the iPECS will not
allow duplicate or conflicting system level codes unless the ‘*’ and Authorization table indexing is used to enter
codes. Conflicting codes occur when a shorter code contains the first digits of a longer code, i.e., 12 conflicts
with 1234.
To Next Page
Loading...
