iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
414
1) Click the Add Function button.
2) On the below window, click the desired PGM in the left frame. First, fill out the function name and
step name. To configure step 1, click the Make table to check the desired function and click the
Save button.
Check All: check all functions
Save: Save the checked functions
Initialize: Initialize the checked functions
3) The selected functions are displayed, and click the Save button after checking each function. The
rest steps are the same as step 1.
To Next Page
Loading...
