iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
415
4) Finally, click the Save Function to save and then click the OK button.
5) To check the function, click the Function Base button in the left frame and User Function List, and
you will see the following figure.
You can enable or disable the function by checking each function and clicking the save after setting
Value. Also, move to each step by clicking the next button or the Previous button.
Deleting Function
To delete the user function, click Maintenance at the top of the window and click the Function Program -> User
Function Management. Check the desired function to delete and click the delete button.
To Next Page
Loading...
