iPECS UCP600 - Page 525

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
84
4.3.2.5 Flexible Numbering Plan part A to D - PGM 106 to 109
Feature dial codes for the system can be assigned using the system‘s Flexible Numbering Plan. Feature
codes should be one (1) to four (4) digits in length and must not conflict. For example, Feature dial codes 53
and 536 represent a conflict. The system will generate an error tone and will not update the database.
Table 3.3.2.5-1 to Table 3.3.2.5-4 below show the defaults for the 1st base Numbering Plan. Appendix B
provides the default values for each of the 9 basic Numbering Plans. Select the base Numbering Plan in PGM
100. The default is based on Numbering plan 1.
PROCEDURE
FLEX NUMBERING PLAN A
PRESS FLEX KEY (01-24)
Press the [PGM] button and dial:
- 106 for part A
- 107 for part B
- 108 for part C
- 109 for part D.
Select the desired button (01~24); refer to Table 3.3.2.5-1 to Table
3.3.2.5-4 for PGM 106 to 109, respectively.
Use the dial-pad to enter desired data. Where a range is required,
input the first and last numbers in the range.
Press the [Save] button to store the new Numbering Plan data.
Table 3.3.2.5-1 FLEXIBLE NUMBERING PLAN PART A (PGM 106)
BTN
DISPLAY
FEATURE
DEFAULT
1
INT PAGE ZONES
START& END:301-335
Internal Page Zone access codes.
eMG80/100:301~335, eMG800:301~400
Refer to
description
2
INT ALL CALL
ENTER NEW #:543
Internal All Call Page access code.
543
3
MEET ME PAGE
ENTER NEW #:544
Meet-Me-Page answer code.
544
4
EXT PAGE ZONE 1
ENTER NEW #:545
External Page Zone 1 access code.
545
5
EXT PAGE ZONE 2
ENTER NEW #:546
External Page Zone 2 access code.
546
6
EXT ALL CALL
ENTER NEW #:548
External All Call Page access code.
548
7
ALL CALL PAGE
ENTER NEW #:549
All Call Page access code.
549