iPECS UCP600 - Page 549

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
108
Table 3.3.3.3-1 STATION ISDN ATTRIBUTES (PGM 114)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
24-20
100-110 LARGE WIN TMR
(0-5) : 0
When the large popup timer is set to any
value from 1 to 5 except 0, the display of
the large popup disappears after the timer
expired and then the large popup
information is displayed at the top bar.
0-5
0
24-21
100-110 MWI LED
(0-4) : ALL MWI
Users can program a Message wait lamp
for each type. Refer to the range.
0: All MWI , 1: VM MWI, 2: CLI MWI,
3: SMS MW, 4: ICM MWI
Refer to
description
ALL MWI
24-22
100-110 NFC AUTH USE
(1:ON/0:OFF ) : ON
If this option is ON, User enters
Authorization code to use NFC function
only for LIP-9071.
0: OFF
1: ON
ON
24-23
100-110 SHORT MODEM
(1:ON/0:OFF ) : OFF
If this value of SLT is ON, SLT is the
modem mode in seizing a co-line.
When the CO line is CO Board, the {short
modem timer} is starting when the SLT
seizes the CO line. And if the {short modem
timer} is expired, the SLT goes to the
original mode.
When the CO line is ISDN, the {short
modem timer} is starting after receiving the
ISDN connect message. And if the {short
modem timer} is expired, the SLT goes to
the original mode.
0: OFF
1: ON
OFF