iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
115
4.3.3.6 CO/IP Group Access – PGM 117
Stations can be allowed or denied access to CO Lines and IP Channels by group(eMG80/100: 20
/eMG800:200), refer to CO Line Attributes, PGM 141, button 1.
As a default, all stations are allowed access to all groups except Private Lines (group 00) and unused CO
Lines.
The CO Line of an RSGM is assigned as a Private Line by default.
CO/IP GROUP ACCESS
ENTER STA RANGE
Press the [PGM] button and dial 117.
100 – 110 CO/IP GRP
PRESS FLEX KEY (01-20)
Use the dial-pad to enter a station range (Ex. 100~110). For a single
station, enter the same number twice.
The first 20 Flex button LEDs indicate group access for eMG.
Press the desired Flex button to toggle CO/IP Group access,
- LED on: group access allowed
- LED off: group access not allowed
Press the [Save] button to store the data entry.
4.3.3.7 Internal Page Zone Access – PGM 118
Each iPECS IP and LDP Phone is assigned to receive announcements from each Internal Page Zone.
A station can be assigned to any, all, or no-zones. Note a remote station or a station not assigned to any
Internal Zone will not receive any page announcements, including Internal All Call.
As a default, all stations except remote stations are assigned to zone 1.
INTERNAL PAGE ZONE
ENTER STA NUMBER
Press the [PGM] button and dial 118.
100-110 I-PAGE ZONE
PRESS FLEX KEY (001-024)
Use the dial-pad to enter a station range (Ex. 100~110). For a single
station, enter the same number twice.
The LEDs indicate the status for Page Zones 1 to 24. Use the [VOL
UP]/[VOL DOWN] button to display Page Zones 25 to 35.
Press the desired Flex button to toggle Internal Page Zone assignments,
- LED On: station receives the announcement
- LED Off: station does not receive the announcement.
Press the [Save] button to store the Page Zone data.
To Next Page
Loading...
