iPECS UCP600 - Page 573

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
132
Table 3.3.4.3-1 BOARD ATTRIBUTES (PGM 132)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
7
001-002 T38 ENABLE
(1:ON/0:OFF) : OFF
T38 mode ON/OFF for FAX datatransfer.
0: OFF
1: ON
OFF
8
001-002 USE BRD IP FWIP
(1:ON/0:OFF) : OFF
VOIB IP will be used for SIP signaling in Multi
NATcircumstance.
0: OFF
1: ON
OFF
9
001-002 RTP FIRWALL IP
0 .0 .0 .0
Enter the Firewall IP address associated with
the RemotePhone or Gateway/board if there
needs a Dual Broadband connection forSIP
trunks and Remote phones(using a VOIB).
0.0.0.0
10
001-002 T38 PORT USAGE
(0:D/1:S/2:T) : 0
T38 Port can be different with
Voice Port. Or, be same or betriggered.
0: D
1: S
2: T
0
11
001-002 2833 PAYLOAD
(000-127) : 000
RFC 2833 Payload is programmable.
000-127
000
12
001-002 2833 VOLUME
(00-36) : 00
RFC 2833 packet volume.
00-36
00
13
001-002 2833 REDUNDANCY
(1-8) : 0
RFC2833 Packet Redundancy.
1-8
0
14
001-002 WEB CONNECT
(1:ON/0:OFF) : OFF
Setting for web connection.
0: OFF
1: ON
ON
15
001-002 TELNET CONNECT
(1:ON/0:OFF) : OFF
Setting for Telnet connection.
0: OFF
1: ON
OFF