iPECS UCP600 - Page 576

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
135
Table 3.3.5.2-1 CO/IP ATTRIBUTES I (PGM 141)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
DEFAULT
13
01-02 WAIT IF VSF BUSY
(1:ON/0:OFF) : ON
When a DID/DISA call assigned to receive a
VMIU/VMIB announcement arrives, and all channels are
busy, the call may wait with Ring back until a channel is
available (ON) or route to the DID/DISA Destination -
PGM 167.
ON
14-15
01-02UNUSED
16
01-02 RING TONE
(00-12, 0:N/A) : 00
Ring Tone can be programmable by CO-line base
admin.
00
17
01-02 UNUSED
18
01-02 GAIN TABLE
(1-3) : 1
TDM gain table can be programmed.
1
19
01-02 TONE TBL
(1-5) : 1
Tone table can be programmed.
1
20
01-02 DGT CONV. TBL
(01-15) : 01
Select digit conversion table.
01
21
01-02 PREPAID CALL
(1:ON/0:OFF) : OFF
Enables Pre-paid Call feature.
OFF
22
01-02 PREPAID MONEY
0 (USED:0)
An amount can be associated with the station as a
prepayment for outgoing calls. The assigned “Pre-paid
Money” is reduced by the calculated call cost (Call
Metering or cost/minute). This parameter displays the
remaining funds for outgoing calls. Prepaid Money is
often used in small hospitality businesses.
The “Used Pre-paid Money” displays the money that
has been used.
23
01-02 LDT ZONE
(001-100) : 001
If the LDT Zone Number of a station/co line is equal to
this value, this LDT table is available to the station/co
line.
001
24
ADDED CO/IP ATTRIBUTE 1
PRESS FLEX KEY (1-2)