iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
136
Table 3.3.5.2-1 CO/IP ATTRIBUTES I (PGM 141)
01-02 ICLID USAGE
(0-2) : CLI
An incoming call can be routed to the destination based
on the Calling Name.
Disable - ICLID feature is disabled
CLI - ICLID feature is operated with CLI
Name - ICLID feature is operated with Name
01-02 EMERGENCY PBX C
(0-4) : DISABLE
The system can insert PBX code automatically if pre-
configured when a user makes an emergency call.
Table 3.3.5.2-2 CO/IP ATTRIBUTES II (PGM 142)
01-02 CO NAME DISPLAY
(1:ON/0:OFF) : OFF
IF ASSIGNED, the IP Phone display can indicate the
CO Line/IP channel number or a twelve (12)-character
name.
01-02 CO NAME ASSIGN
…………
Each CO Line and the IP group can be assigned twelve
(12) character names for display purposes. See Table
3.1.2-1 for the character entry sequence.
01-02 METERING UNIT
00:NONE (0-6)
Selects the call-metering signal from the PSTN to
indicate call cost. Refer to Table 3.3.5.2-5.
01-02 LINE DROP(CPT)
(1:ON/0:OFF) : OFF
Each CO Line can be programmed to disconnect if an
error tone is detected.
01-02 DISA ACCT CODE
(1:ON/0:OFF) : ON
With DISA ACCT CODE “ON,” users will be required to
enter an Authorization code. Enter codes in
Authorization Codes Table - PGM 227.
01-02 MOH: (00-37)
MUSIC 1 (01)
A held call can be connected to one of three possible
audio sources while on Hold as Music-on-Hold (MOH).
00:REFER TO SYS HOLD,
01: INT MUSIC
02: EXT MUSIC
03: VSF MOH
04~08: SLT MOH1~5
09~10: VSF MOH2~3
11~37: VSF MOH4~30
01-02 CO DIAL TONE
(1:ON/0:OFF) : ON
ISDN Lines may provide a digital signal rather than
actual tones. If the ISDN tone is set to “OFF,” iPECS
can provide the tones.
01-02 CO RBACK TONE
(1:ON/0:OFF) : OFF
ISDN Lines may provide a digital signal rather than
actual tones. If the ISDN tone is set to “OFF,” iPECS
can provide the tones.
To Next Page
Loading...
