iPECS UCP600 - Page 578

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
137
Table 3.3.5.2-2 CO/IP ATTRIBUTES II (PGM 142)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
DEFAULT
9
01-02 CO ERROR TONE
(1:ON/0:OFF) : OFF
OFF
10
01-02 CO BUSY TONE
(1:ON/0:OFF) : OFF
OFF
11
01-02 DISA CO ACCESS
(1:ON/0:OFF) : OFF
Permits DISA users access to the VoIP facilities of the
system.
OFF
12
01-02 FLASH TMR
(000-300 10 ms) : 050
This entry sets the duration of a Flash on the CO Line.
050
500 msec
13
01-02 OPEN LOOP
(00-20 100ms) : 04
This entry sets the duration of the open loop that will be
recognized as a “Disconnect Signal.”
04
14
01-02 ICLI DT TMR
(00-20 SEC) : 00
When a call is received, the system may use the ICLID
(Incoming Caller ID) to route the call. The system will
delay routing a call for this timer while awaiting ICLID.
Enter a 00 to disable ICLID routing.
00
15
01-02 SMS OUTGOING
(1:EN/0:DIS) : DISABLE
Each CO line can be assigned to support PSTN SMS.
Disable
16
01-02 SMS RCV STATION
STA : ….
When a PSTN SMS is received, the system delivers the
message to the assigned station.
….
17
01-02 DL TN:(00-37)
DIAL TONE (00)
One of the below dial tones can be used by the CO line.
 00:DIAL TONE
 01:INT MUSIC
 02:EXT MUSIC
 03:VSF MOH
 04~08: SLT MOH1~5
 09~10: VSF MOH2~3
 11~37: VSF MOH4~30
Dial tone
18
01-02 RB TN: (00-37)
RING BACK TONE (00)
One of the below ring back tones can be used by the
CO line.
 00:RING BACK TONE
 01:INT MUSIC
 02:EXT MUSIC
 03:VSF MOH
 04~08: SLT MOH1~5
 09~10: VSF MOH2~3
 11~37: VSF MOH4~30
Ring back
tone