iPECS UCP600 - Page 632

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
191
Table 3.3.6.17-1 SMDR ATTRIBUTES (PGM 177)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
24-18
VSF VM DISPLAY
(0:’I’, 1:’V’)
If the value is ‘I’, the call to “VSF voice mail”
is displayed as ‘I’ in SMDR.
But if the value is ‘V’,the call to “VSF voice
mail” is displayed as ‘V’ in SMDR.
‘I’ means “incoming call”.
‘V’ is new indication for “VSF voice mail”.
0:’I’
1:’V’
0:’I’
24-19
DISPLAY N TYPE
(1:ON/0:OFF) : OFF
Display ‘N’ in SMDR to distinguish and it is
network call.
1:ON
2:OFF
OFF
24-20
OUTGOING CALL TYPE
(0:ALL/1:ANSWER) : ALL
ALL : all of outgoing call
ANSWER : Answered outgoing call
Refer to
description
ALL
24-21
PRINT DIALED DIGIT
(0:PSTN/1:USER) : PSTN
PSTN : Outgoing digits to PSTN
USER : Dialed digits by user
0: PSTN
1: USER
PSTN
24-22
SMDR ICM Ring Info
(1:ON/0:OFF) : OFF
When enabled, intercom call data has
additional information about ringing
duration. With this option disabled, cannot
disfferentiate calls if they are answered or
unanswered because TIME field is used for
both of talking and ringing durations. With
this option enabled, TIME is only for talking
duration, and RING duration is presented
separately as it is presented for CO call
data.
0: OFF
1: ON
OFF
24-23
SMDR ICM CPN Info
(1:ON/0:OFF) : OFF
When enabled, intercom call data has
additional information about original dialed
digits. With this option disabled, always
only the last talking or ringing station is
specified as called party. With this option
enabled, the original dialed number is
presented separately in CPN field.
0: OFF
1: ON
OFF