iPECS UCP600 - Page 633

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
192
4.3.6.18 System Date, Time and Daylight Saving Time (DST) – PGM 178
This entry establishes the system Date, Time, and DST features.
The date and time are employed for several features and functions, including; LCR, LCD displays, SMDR
outputs, Auto Ring Mode Selection, Wake-Up Alarm, etc.
If DST is enabled, the system time will be adjusted one hour forward and back at the DST start and end times,
respectively.
PROCEDURE
SET TIME/DATE & DST
PRESS FLEX_KEY (1 - 5)
Press the [PGM] button and dial 178.
Press the Flex button for the desired Attribute; refer to Table 3.3.6.18-1.
- Button 1: Time
- Button 2: Date
- Button 3: DST enable mode
- Button 4: DST start time
- Button 5: DST end time
Use the dial-pad to enter desired data for the Attribute
Refer to Table 3.3.6.18-1.
Press the [Save] button to store the data entry.
Table 3.3.6.18-1 SYSTEM TIME, DATE & DST (PGM 178)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
SET TIME
TIME 00:22(HH:MM)
Sets the system time.
HH:MM
2
SET DATE
DATE: 07/24/13(MMDDYY)
Set the system date.
MMDDYY
3
DST ENABLE MODE
(1:ON/0:OFF) : OFF
Enable DST feature for System Time.
0: OFF
1: ON
OFF
4
DST START TIME
ONLY POSSIBLE BY WEBADM
The DST start time.
It can be set only via WEB Admin.
2ndSunday of March at2:00 AM
See DST
Table
Refer to
description
5
DST END TIME
ONLY POSSIBLE BY WEBADM
The DST end time.
It can be set only via WEB Admin.
1stSunday in Nov. at2:00 AM
See DST
Table
Refer to
description