iPECS UCP600 - Page 663

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
222
Table 3.3.7.2-7 STATION GROUP ATTRIBUTES — UMS GROUP (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
13
UMS 410 WRAP-UP TMR
(002 – 999) : 002
After terminating any call, the VM port will
be maintained in a busy state for the
duration of the WRAP-UP Timer.
002~999
seconds
002
14
FORCED FWD DEST USAGE
(1:ON/0:OFF): OFF
Enables the system to redirect group calls
to the Forced destination defined under
button 15 below.
0: OFF
1: ON
OFF
15
UMS 410 FORCED DEST
S/H/V/SPD (DIAL 1-4)
When a call is delivered to the group, the
system can redirect the call to the Forced
destination if enabled under button 14
above.
1:Station, 2:Station group
3:VSFAnnounce, 4:System speed
Refer to
description
-
16
GROUP NAME
……………………………….
A hunt group name can be designated.
20
character
….
Table 3.3.7.2-8 STATION GROUP ATTRIBUTES — UCS SERVER GROUP (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
UCS SVR [411] ASSIGNED
UC Server 1 (01–16)
UCS Server number, this value must be set
to 1.
01-16
1
4.3.7.3 Pick Up Group Assignment – PGM 192
Under Pick-Up Group Assignments, members are assigned to the Station Pick Up Group.
PROCEDURE
PICKUP GRP ASSIGN
ENTER GRP NUM(00-49)
Press the [PGM] button and dial 192 and enter group number (Ex. 00).
(eMG80/100:00~49/ eMG800:0~199)
PICKUP GRP 00
…. …. ….
Use the dial pad to enter the desired Pickup Group.
The system will display the member of the pickup group.
PICKUP GRP 00
…. …. ….
Note for group members, enter a station or station range. For an individual
station, press the desired Flex button for the station's position in the group
and dial the station number. For a range, enter the first and last station
numbers in the range.
Press the [Save] button to store the data entry.