iPECS UCP600 - Page 662

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
221
Table 3.3.7.2-7 STATION GROUP ATTRIBUTES — UMS GROUP (PGM 191)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
4
UMS 410 ANNC2 LOC
VSF ANNC .. (01 – 70)
The Station Hunt Group can be assigned a
2nd announcement, which is played if the
call remains queued beyond the ANNC 2
TMR duration. The announcement location
is the VSF ANNC2 number. An entry of 00
indicates no announcement. Including ‘#’ at
the end of an entry instructs the system to
disconnect after the announcement.
01~70
00: none
5
UMS 410 ANNC2 RPT TMR
(000 - 999) : 000.
The 2nd announcement can be repeated to
calls that remain in the queue at intervals of
the Announcement 2 RepeatTimer. Note;
repeating must be “ON” under button 6
below.
000~999
seconds
000
6
UMS 410 ANNC 2 RPT
(1: ON / 0: OFF): OFF
After the 2nd announcement, if the call
remains queued to the group, the 2nd VSF
announcement can be repeated at the
AnnouncementRepeatTimer interval.
0: OFF
1: ON
OFF
7
UMS 410 OVERFLOW DEST
S/H/V/SPD (Dial 1-4)
A call to the group will continue to route
through the group until answered or all
group members have been tried. The call
will remain at the last station or routes to
the assigned OverflowDestination.
1:Station, 2:Station group
3:VSFAnnounce, 4:System speed
Refer to
description
8
UMS 410 OVERFLOW TMR
(000 - 600) : 180
A call to a group will remain at the last
station in the group or can be sent to the
assigned OverflowDestination after the
expiration of the OVERFLOW Timer.
000~600
seconds
180
9
UMS 410 NANS TMR(1s)
(00 – 99) : 15
Calls to a station in the group are directed
to the station. If unavailable or unanswered
in the NO AnswerTimer, the call can be
routed based on the assigned hunt
process.
00~99
seconds
15
10
UMS 410 PILOT HUNT
(1 : ON/ 0: OFF) : ON
An FS VM group can be set so that only
calls to the pilot number (station group
number) will hunt.
0: OFF
1: ON
ON
11
UMS 410 ALTER DEST
STA/HUNT
When a call comes into the group, and
there are no group members available, the
call will be routed to the assigned
AlternateDestination.
Station or
Group
Number
....
12
UMS 410 HUNT TYPE
(1 : CIRC/ 0 : TERM): CIR
When a call is offered to the group, the
Hunt process can be defined for Circular or
Terminal hunt group.
0: TERM
1: CIR
CIR