iPECS UCP600 - Page 668

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
227
4.3.8.5 ICLID Ring Assignment – PGM 204
If the Incoming Caller ID matches an entry in the ICLID Route Table, the index from the Table is used to
determine the call routing from the ICLID Ring Assignment Table.
Separate ring assignments are made for Day, Night, and Timed Ring mode for each index, 001 to 250, in this
table. When assigned to ring to a VSF announcement, the call can be automatically dropped after the
announcement by entering ‘#’ after the announcement number.
When CO Lines are programmed to Ring an external AA/VM, VSF, or Feature Server Group as an Automated
Attendant, the Ring signal can be immediate or delayed, allowing other stations/groups to be assigned Ring
and answer prior to signaling the AA. The delay is defined in seconds from 00 to 30.
PROCEDURE
ICLID RING ASN TBL ATT
ENTER BIN NO (001-250)
Press the [PGM] button and dial 204, and enter the bin number (Ex.001).
PRESS KEY
DAY NIGHT TIMED-R
Use the dial pad to enter the Index or Bin number (001 – 250).
Press the desired Flex button:
- Button 1: Day Ring
- Button 2: Night Ring
- Button 3: Timed Ring
Use the dial pad to select the destination type:
- Dial 1: Station
- Dial 2: Hunt Group
- Dial 3: VSF Announcement
- Dial 4: AA Ring Time
- Dial 5 : Net number
Use the dial pad to enter a value for the selected destination type.
Press the [Save] button to store the data entry.