iPECS UCP600 - Page 69

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
55
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Speed Dial
Access
Allows the station to access System Speed Dial bins.
Disable
Enable
Enable
Alarm/Door Bell
Assigns a station to receive the Alarm/Door Bell signal.
Disable
Enable
Disable
Station Account
When ON, the station user must enter an authorization code to
access CO/IP Lines.
OFF
ON
OFF
Forced SMDR
Account Code
When On, the user must enter an Account code to place an
outgoing call.
OFF
ON
OFF
Loop LCR
Account
The Station may be required to enter a Station Authorization code
to access loop LCR operation.
OFF
ON
OFF
Door Open
Enable use of the Door open feature by the station.
Disable
Enable
Enable
Flex Button
PGM
The iPECS IP and LDP Phones can control the ability to assign
Flexible buttons. The user may assign features to Flexible buttons
but requires special assignments to configure CO/IP Line buttons
when allowed here.
OFF
ON
ON
Prefer CO or
Group
The System will seize this CO/IP Line or a Line from the CO/IP
group number when the station dials “9” (First available Co-
access code)
CO, IP Line, CO Group number
Refer to
description
Access
code
Emergency CO
or Group
This field defines the CO/IP Line or Group employed by the
system to place Emergency Assistance calls.
CO #, CO Group #
Refer to
description
Any CO
ICM Tenancy
Group
Assign stations to an ICM Tenancy Group.
eMG80/100:1~15, eMG800:0~32, UCP:0~100
Refer to
description
1
Call Time
Restriction
All outgoing calls will disconnect at the expiration of the call
Restrict Timer. The Cut-Off Timers can be set the time for Station
and CO Line. For the cut-off timer of the Station, refer to the title
“Station Timers (123)”. Refer to the title “CO Line data: Common
Attributes (144)” for the CO line.
OFF
ON
OFF
Proctor
Monitoring
Power-Fail
Enable use of PABX ANI Link device for E-911support. Only an
SLT port can be used for this feature.
OFF
ON
OFF
Line Release
Cost Display
When a CO/IP line is released, the disconnect cause or call cost
is displayed in the iPECS IP or LDP Phone LCD.
OFF
ON
OFF
Active PTT
Group Number
A station can be assigned to a PTT (Push-to-Talk) group, and the
group is enabled so the station can place and receive PTT
announcements for the group.
0~9
Hot Desk
Station
A station (only IP Phone) can be assigned as a Hot Desk phone.
Users and agents can log in and use resources of the system
through the Hot Desk phone.
OFF
ON
OFF
SMDR Hidden
Dialed Digits
If this feature enables, the dialed digit can be hidden on SMDR
output.
Disable
Enable
Disable