iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
56
Table 4.4.2.2-1 Common Attributes
Left Message
to Executive
When a call forwards to the Secretary of an executive/Secretary
pair, messages can be left for the executive (ON) or Secretary
(OFF).
Based on this level, the user will view the specified programs
within the Station User Web portal. Level 1 can view all programs.
Levels 2 and 3 are configured in the title “System data: Station
Web Authorization.” This is a Web-only PGM.
When a page announcement is received, it is generally played
over the iPECS IP or LDP Phone Speaker. For headset users, the
page can be played to the headset or both the headset and
speaker. SPKR, HEADSET, BOTH
When employing a non-ISDN terminal, specifically a modem or
analog FAX, the ISDN call SETUP message must include this
message, and “Progress Indication” should be set to “ON.”
When an analog device (SLT or FAX) uses an ISDN Line in the
system, the Information Element of the ISDN SETUP message
must indicate the device only has 3.1 KHz audio capabilities. If an
SLT or analog FAX is allowed access to the ISDN Lines, this
parameter must be “ON.”
Pickup by
flexible button
When a station receives a call, the DSS/BLF button at other
stations will flash, and, if allowed, other stations may use the
button to answer (pick-up) the call.
ON: User can pick up by DSS button.
OFF: User can’t pick up by DSS button.
It is a useful feature for users to pay the money within the budget
(Prepaid) for outgoing calls. For more information, refer to the
below feature, “Prepaid money.”
Prepaid Money
(0 - 999999)
&
Used Prepaid
Money
An amount can be associated with the station as a prepayment for
outgoing calls. The assigned “Pre-paid Money” is reduced by the
calculated call cost (Call Metering or cost/minute). This parameter
displays the remaining funds for outgoing calls. Prepaid Money is
often used in small hospitality businesses.
The “Used Pre-paid Money” displays the money that has been
used.
000000 –
999999
000000 -
999999
These fields reference the index to the SIP User ID Attributes
Table. The referenced SIP User ID may be employed for several
of the SIP headers for outgoing calls and may be employed for
incoming call routing as configured in the SIP CO Attributes PGM
133, “ID Assigned Station.”
Up to three SIP User Id indices can be assigned to each station to
permit the use of up to three SIP Trunk service providers.
eMG80/100:0~140, eMG800:0~1200, UCP:0~2400