iPECS UCP600 - Page 75

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
61
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
DISA
Restriction
A call routed using DISA normally routes to the appropriate
station. If desired, a Station can be restricted from receiving DISA
calls.
OFF
ON
OFF
Pre-Selected
Msg DND
When the user activates Pre-Selected or Custom Messages, the
system can automatically activate DND for the station so that the
station will not receive the ring and the call is routed based on the
DND treatment.
OFF
ON
OFF
Private Mode
for External
Mobile or
External
Forwarded
This is about presenting numbers in the display of internal caller's
or callee's station in the following cases.
1) extension 'A' calls extension 'B' that is forwarded to the external
number of 'B.'
 ON: extension number or extension name of 'B' is presented
in the display of extension 'A.'
 OFF: external number of 'B' or SPEED name of the external
number 'B' is presented in the display of extension 'A.'
2) external number that is registered as extension 'B' calls
extension 'A.'
 ON: extension number or extension name of 'B' is presented
in the display of extension 'A.'
 OFF: external number of 'B' or SPEED name of the external
number 'B' is presented in the display of extension 'A.'
OFF
ON
ON
Voice Attributes
Page Access
Stations must be allowed Page access to send a page over the
system’s Paging facilities.
OFF
ON
OFF
Forced hands-
Free Mode
When placing an intercom call, a user can change the ICM
signaling mode, Tone Ring to Hands-free answer mode, or HF
Answer to Tone Ring.
OFF
ON
OFF
Group
Listening
Enables Group Listens to feature. Audio is sent to both the
handset and speaker with the handset microphone active and
speakerphone microphone OFF.
Disable
Enable
Enable
Override
Privilege
Enables intrusion to gain access to an active CO/IP call.
Disable
Enable
Disable
Voice Over
Enable use of Voice Over by the station.
Disable
Enable
Enable
Barge In Mode
Barge-in permits an authorized Station to intrude into other
existing outside/internal calls or to force disconnection existing of
an existing call.
Disable, Only Monitor, Monitor &Join &Disconnect
Refer to
description
Disable
Camp on
enable
The station can receive a Camp-on while busy. If ‘Camp On Tone’
is enabled, the stations receive Camp-on tone. Otherwise, only
the LCD will indicate the camp on call. If the station is not allowed
to receive a Camp-On, the calling user receives an error tone.
OFF
ON
ON