iPECS UCP600 - Page 76

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
62
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Video Show on
Calling (ex. IP
Video Door
Phone)
When VoIP video door phone rings to a video-enabled IPKTS
handset, the video streaming commences immediately while the
IPKTS handset is in the ringing and the video stream continues
when answered.
OFF: normal implementation (video starts after answer)
ON: video stream from this Video Door Phone to the ringing
video-enabled LIP Phone even though this is alerting stage.
Condition: A VOIU/VOIB channel for RTP-Packet-Relay purpose
is required to serve ring-back-tone generation via a DSP channel.
The system does pre-answer to the Video Door Phone even
though the receiving station is in alerting state.
OFF
ON
OFF
Silent intercom
busy service
It is used to mute automatically when making intercom busy
service (intrusion/voice-over), and also it overrides “Ring Group
Service”/”ACD Group Service.”
OFF
ON
OFF
Transfer for
uncomplete call
When a user transfers a call to a busy extension, it defines as
allowing the transfer call. it is not working on the SIP phone
 Transfer: the call is transferred to a busy extension
 Recall: the call is recalled to transferring extension
Refer to
description
Transfer
Block
Transferred
Call
When a user transfers a call to an extension, it defines to allow
the transfer call.
 Allow CO & ICM transfer: Allow CO and ICM call transfer
 Block CO & ICM transfer: Block CO and ICM call transfer
 Block CO transfer: Block CO call transfer
 Block ICM transfer: Block ICM call transfer
Refer to
description
Allow CO &
ICM
transfer
MOH Attributes
Default MOH
for External
Call
Default MOH type that holding party serves for an external call.
 Refer To Zone or Sys MOH,
 Internal Music1,
 External Music2,
 VSF MOH,
 SLT MOH1~5,
 VSF MOH2~30
Refer to
description
Refer To
Zone or Sys
MOH
Default MOH
for Internal Call
Default MOH type that holding party serves for an internal call.
 Refer To Zone or Sys MOH,
 Internal Music1,
 External Music2,
 VSF MOH,
 SLT MOH1~5,
 VSF MOH2~30
Refer to
description
Refer To
Zone or Sys
MOH
Override MOH
Of External
CPN(231)
Default MOH type of holding party can override the MOH of CPN
that is programmed in Flexible DID Conversion Table(231).
OFF
ON
OFF