iPECS UCP600 - Page 77

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
63
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Override MOH
Of CO
Line(140)
Default MOH type of holding party can override the MOH of CO
Line that is programmed in CO Line MOH(140).
OFF
ON
OFF
Zone MOH –
Follow Holding
party Zone
If MOH of device-specific (CO or Station) is set to “Refer To Zone
or Sys MOH” and Zone MOH type is set to a specific MOH that is
not following “Refer To Sys MOH,” MOH is type is decided by
Zone MOH(P439).
OFF
ON
OFF
Sys MOH –
Follow Holding
party
Sys(TNET)
If MOH of device-specific (CO or Station) is set to “Follow Zone or
Sys MOH” and Zone MOH is set to “Refer To Sys MOH,” MOH
type decided by System(P171) or TNET(P335) Music Source
setting.
OFF
ON
OFF