iPECS UCP600 - Page 80

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
66
Table 4.4.2.3-1Terminal Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Large Popup
Timer
When the large popup timer is set to any value from 1 to 5 except
0, the display of the large popup disappears after the timer
expired, and then the large popup information is displayed at the
top bar.
0~5
(Sec.)
0
NFC
Authorization
code Use
If this option is ON, the User enters the Authorization code to use
the NFC function for LIP-9071.
OFF
ON
ON
LCD Dimming
Apply
If this option is ON, LCD dimming is available only for LIP-9000
Series and LDP-9240D. LCD is dark when the phone is paused,
so some light is needed. So we provide dimmable lights.
OFF
ON
OFF
UCS ACD Use
If the ACD (Automatic Call Distribution) option is set to ON, the
ACD menu is displayed on Tools of UCS. UCS can use ACD
login/logout and ACD On/Off Duty.
OFF
ON
OFF
UCS CRM Use
If the CRM (Customer Relationship Management) option is set to
ON, the CRM menu is displayed, and the CRM installation tray
icon is displayed on Tools of UCS. UCS can use the CRM
function after the installation of CRM integration.
OFF
ON
OFF
UCS DIALING
RULE USE
UCS client users can use the ‘Dialing Rule’ of UCS client such as
CO Access, PBX code, Country Code, Area code, International
Call, Long distance call, Add zero setting, etc., by setting ON.
But, if this option is OFF, the UCS Client user follows the ‘System
Dialing Rule’ such as Digit Conversion and LCR.
OFF
ON
OFF
UCS MOBILE
DIAL USE
(ANDROID’S)
This option is only for the Android UCS Client. If this option is
ON, the UCS client user can call using the UCS client application.
But, if this option is OFF, the UCS client user places a call by
Mobile Network (Communication network where the last link is
wireless).
OFF
ON
OFF
UCS PUSH
POLLING Use
It is only used for iOS clients that are not ringing or long delay to
ring when receiving a PUSH message. If it is ON, the system
sends a PUSH polling message so that the UCS application will
wake up periodically. so it could consume more batter
ON: System sends a PUSH polling message
OFF: The system does not send a PUSH polling message
OFF
ON
OFF
Message Wait
Button
Users can program MWI (Message Wait Indication) LED
according to the following type:
 All Messages: LED is blinking about all calls and
Messages.
 Voice Mail: blinking in case of getting Voice mail.
 Missed Call: blinking in case of being Missed call.
 SMS: blinking in case of getting Short message
 ICM Call Back: blinking in case of Incoming call
Refer to
description
All
Message
PGM button
If this option is set to Enable, you can access Programming by
pressing the PGM button.
Disable
Enable
Enable