iPECS UCP600 - Page 82

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
68
Table 4.4.2.3-1Terminal Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Allow to Stop -
Flexible Paging
Permission to stop ongoing announce or silent message paging
<To Stop/Cancel Page initiated by Me>
 In condition, Allow to Stop Flexible Paging = “Allow to Stop
Initiated by Me Only” or “Allow to Stop Initiated by Any One”
 Dial the Stop/Cancel Code or press the One-Touch flex
button that has the code: Flexible Page Prefix Code + 00
(ex. *7400)
< To Stop/Cancel Page initiated by All (including Me)>
 In condition, Allow to Stop Flexible Paging = “Allow to Stop
Initiated by Any One”
 Dial the Stop/Cancel Code or press the One-Touch flex
button that has the code: Flexible Page Prefix Code + ** (ex.
*7***)
Not Allow to Stop, Allow to Stop Initiated by Me Only,
Allow to Stop Initiated by Any One
Refer to
description
Not Allow
to Stop
Separated Flex
Button in Call
Control
It is used only for IP Attendant No Voice mode login.
The IP ATD flex button is synchronized with the hard phone's flex
button if this option is OFF.
If this option is ON, the IP ATD flex button is worked individually.
OFF
ON
OFF
SLT Attributes
Data Security
Disable override and camp-on tones to the station. This feature
is commonly used for an analog modem or FAX to assure tones
do not affect received information.
OFF
ON
OFF
ECM Faxes in
T.38
ECM stands for Error Correction Mode. If you failed to send
something via Faxes, you could send it again until it is
successful.
Allow,
Prevent
Allow
MODEM Enable
When an SLT port is connected to a Modem, the port can be
enabled for Modem operation. This will activate Echo
Cancellation and disregard any Camp-on/Call Wait to improve
modem performance.
OFF
ON
OFF
SLT CID TYPE
Caller ID can be sent to an SLT as FSK or DTMF signals.
FSK
DTMF
FSK
Send SLT CLI Info
When allowed, the system sends CLI (Calling Line Identification)
information to SLT.
OFF
ON
ON
SLT Flash Mode
When an SLT activates a Hook-flash the system will perform
one of the following operations:
 Flash Transfer: the active call is placed on hold, and the
dial tone is returned.
 Flash-Drop: the active call is dropped.
 Flash-Ignore: the Hook-flash is ignored, no action is taken.
 Hold Release: the active call is placed on hold, and if the
SLT returns to idle, the call is dropped.
Refer to
description
Flash
Transfer
SLT configuration
mode
For the South African region, the SLT gain is adjusted based on
the SLT Configuration Mode. Default, Short, Long, Far
Refer to
description
Default