iPECS UCP600 - Page 83

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
69
Table 4.4.2.3-1Terminal Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Block Back Call
When an SLT attempts to transfer a CO/IP call to another CO/IP
Line, the transfer can be blocked, and the call released.
OFF
ON
OFF
SLT Open Loop
Time
Send open-loop signal to SLT port when counter party user
hangs up SLT.
0~9
(100ms)
0
Short Modem
If this value of an SLT is ON, the SLT is the modem mode in
seizing a CO line. When the CO line is CO board, the {short
modem timer} is starting when the SLT seizes the CO line. And
if the {short modem timer} is expired, the SLT goes to the
original mode. When the CO line is ISDN, the {short modem
timer} is starting after receiving the ISDN connect message. And
if the {short modem timer} is expired, the SLT goes to the
original mode.
OFF
ON
OFF
Line Echo
When LKA-200 SLT is used, the echo may be hearing. If this
option is set to ON, the echo won’t happen.
OFF
ON
OFF