iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
73
Table 4.4.2.4-1 CLI Attributes
The system provides CLI information by displaying it on LCD. If
this option is ON, the full CLI information is displayed on the
second line of LCD.
The CLI information is partially displayed from the left to the
center on the second line if the option is OFF. It means the CLI
information is limited so that the full CLI can’t be displayed.
Add 1st CO group
access code in call
log
To use this option, 'Digit Conv. Table (PGM 111)' must be
checked in advance and then set whether to add 1st CO
Group access code in call log for Call back by setting ON or
OFF.
Emergency CLI is used for CLI if the dialed number is matched
with Emergency Code Table(PGM226).
It is used to send name to ISDN(PRI/BRI)
eMG80/100: 1~16, eMG800: 1~100,UCP: 1~1000,
(0: Station name)
Most Phones show the call log. But the way to display the call
log is different between System Serve and Phone self. This
option is to select which way to display the call log. The
available phone type is LIP-8012D/8024D/8040L and LIP-
9008/9010/9020/9030/9040/1010i/1020i/1030i/1040i/1050i.
Condition
For color graphic phones (8050V/9070/9071,1080i), UCS
client, and DECT phone: only 'Phone self' automatically
regardless of this option.
For other phone types except for the above LIP and LDP
phones: only 'System serve' automatically regardless of
this option.
System serve, Phone self
This option selects the call log menu for a call log type.
The call log types have 4: Lost call, All call, Received call, and
Dialed call.
ALL: display all calls.
Type: display the call log 4 types and then select the
desired type.
To Next Page
Loading...
