Lexmark 7462 series - Page 99

5 Remove the jammed paper.
6 Close the bottom rear door.
7 Insert the standard tray.
8 To uc h Continue.
230 error messages
Error code Description Action
230.00 Paper jam around internal duplex (internal duplex)
Page may be jammed in internal duplex area.
Go to
“Paper jam around internal duplex
service check” on page 100.
230.01 Sensor (duplex input) lingering jam (internal
duplex)
Media reached the sensor (duplex input) but did
not clear it in the
specified
time.
Go to
“Sensor (pass through) late jam service
check” on page 101.
230.02 Sensor (duplex input) late jam (internal duplex)
Media is late reaching the sensor (duplex input)
within the specified time.
Go to
“Sensor (duplex input) late jam service
check” on page 103.
230.03 Sensor (duplex input) bounce (internal duplex)
The sensor (duplex input) rebounded once the
trailing edge of the media passed.
Go to
“Sensor (duplex input) service check” on
page 105.
230.04 Sensor (input) late jam from duplex (internal
duplex)
Media is late reaching the sensor (input) within the
specified
time during the second side printing
using the internal duplex.
Go to
“Sensor (input) late jam service check”
on page 73.
230.05 Sensor (duplex input) lingering jam (internal
duplex)
Media reached the sensor (duplex input) but did
not clear it in the
specified
time.
Go to
“Sensor (pass through) late jam service
check” on page 101.
230.06 Sensor (input) late jam from duplex (internal
duplex)
Media is late reaching the sensor (input) within the
specified
time during the second side printing
using the internal duplex.
Go to
“Sensor (input) late jam service check”
on page 73.
230.07 Sensor (input) late jam from duplex (internal
duplex)
Media is late reaching the sensor (input) within the
specified
time during the second side printing
using the internal duplex.
230.08 Internal duplex drive motor load error (internal
duplex)
The internal duplex drive motor assembly has
failed or caused high mechanical load during
warm-up sequence.
Go to
“Internal duplex drive motor load error
service check” on page 105.
7462
Diagnostic information
99